Client Connection: POP3 IMAP

Fields with the asterisk * are mandatory.

Properties	Description
NAME *	Name of the POP3 IMAP connection you are creating. The maximum number of characters is 128. Blanks and these special characters: ' " | are not supported.
DESCRIPTION	Description of the POP3 IMAP connection you are creating. The maximum number of characters is 2048.
STATUS	Enable or disable the client connection. Possible values: Enabled (default value) Disabled
HOST *	Remote host IP Address or hostname.
PORT *	Port to connect to the remote host (1 to 65535).
USERNAME *	Username to be used for the connection. The maximum number of characters is 320.
PASSWORD *	User password.
MATCH SERVER HOSTNAME	Possible values: Enabled Disabled (default value) When set to Enabled, the Client verifies that the Distinguished Name (DN) certificate contains the IP that has been contacted (i.e., the HOST value above).
CLIENT KEY LABEL	Key identifier to create the SSL connection
SSL AUTHENTICATION PROTOCOL	Select the SSL authentication protocol: ALL ONLY SPECIFIC VALUES: SSLv3 TLSv1 TLSv1_1 TLSv1_2 TLSv1_3 SSLv2Hello
ACCEPTED CIPHER SUITES	Select the cipher suites. ALL or specific values in the drop-down list (See ACCEPTED CIPHER SUITES): ALL ONLY SPECIFIC VALUES
STORE TYPE	IMAP (default): Get email but leave a copy on the server POP3 Get email and delete it on the server
FOLDER *	Folder where the email will be saved.
CONNECTION SECURITY	Enable a secure connection: STARTTLS SSL_TLS NONE
DISPOSITION	Action after polling: DELETE KEEP SEEN
PULL DISPOSITION	Email to get: GET_FIRST_MESSAGE GET_FIRST_UNREAD_MESSAGE GET_LAST_MESSAGE GET_LAST_UNREAD_MESSAGE NOTE: “first message” means the oldest.
MAX RETRIES	Maximum number of retries. If this field is empty or set to 0, no retries will be executed and the job will be set to Failed if the first attempt is not successful. A high value corresponds to a high number of retrying attempts.
RETRY INTERVAL	This field will appear only if you have set the maximum numbers of retries to 1 or greater. Time (in seconds) waited before retrying executing a job. The lower the value, the more frequent the retrying attempts. If this field is empty or set to 0, no retries will be executed and the job will be set to Failed if the first attempt is not successful.
CONFIGURATION TEST	Use this section to test that the Cluster and the STENG are connected correctly. Select a Cluster and a STENG you want to test and click the TEST button. Data One automatically selects a Cluster and a STENG to test the connection. Note that a Cluster will be selected only if it is the only one available. A message with a green check will confirm a successful connection. A message with a red exclamation mark will warn about an unsuccessful connection. The message also details the reason why the connection fails. The connection might not be successful for different reasons, each of them depending on the transport type and the configuration. The first time you try to test the connection, if trusting certificates are missing, an error message detailing the unsuccessful connection will appear. In this case, go to the Setup → Untrusted Cache → Certificates tab and trust the relevant certificates. Note that trusting certificates in the Untrusted Cache page may not be sufficient to establish a successful connection. Refer to the Untrusted Cache section of this documentation for all the details.