Client Connection: SMB v3 or later versions
Last updated
Last updated
Fields with the asterisk * are mandatory.
NAME *
Name of the SMB v3 connection you are creating. The maximum number of characters is 128. Blanks and these special characters: ' " | are not supported.
DESCRIPTION
Description of the SMB v3 connection you are creating. The maximum number of characters is 2048.
STATUS
Enable or disable the client connection. Possible values:
Enabled (default value)
Disabled
HOST *
Remote host IP Address or hostname.
PORT *
Port to connect to the remote host (1 to 65535).
NETBIOS FALLBACK
When creating a new SMB3 client connection, this button is enabled by default, but you can change it as needed. When enabled, NetBIOS port 139 is used in case of connection errors.
USERNAME *
Username to be used for the connection. The maximum number of characters is 320.
PASSWORD *
User password.
DOMAIN*
User domain.
SHARE NAME*
Name of the share to be mounted.
BUFFER SIZE *
Size of the buffer to be used when reading/writing data. Default value: 1 MB
MAX RETRIES
Maximum number of retries. If this field is empty or set to 0, no retries will be executed and the job will be set to Failed if the first attempt is not successful. A high value corresponds to a high number of retrying attempts.
RETRY INTERVAL
This field will appear only if you have set the maximum numbers of retries to 1 or greater. Time (in seconds) waited before retrying executing a job. The lower the value, the more frequent the retrying attempts. If this field is empty or set to 0, no retries will be executed and the job will be set to Failed if the first attempt is not successful.
CONFIGURATION TEST
Use this section to test that the Cluster and the STENG are connected correctly. Select a Cluster and a STENG you want to test and click the TEST button. Data One automatically selects a Cluster and a STENG to test the connection. Note that a Cluster will be selected only if it is the only one available. A message with a green check will confirm a successful connection. A message with a red exclamation mark will warn about an unsuccessful connection. The message also details the reason why the connection fails. The connection might not be successful for different reasons, each of them depending on the transport type and the configuration. The first time you try to test the connection, if trusting certificates are missing, an error message detailing the unsuccessful connection will appear. In this case, go to the Setup → Untrusted Cache → Certificates tab and trust the relevant certificates. Note that trusting certificates in the Untrusted Cache page may not be sufficient to establish a successful connection. Refer to the section of this documentation for all the details.