Client Connection: PR4/PR4S

Fields with the asterisk * are mandatory.

Properties
Description

NAME *

Name of the PR4/PR4S connection you are creating. The maximum number of characters is 128. Blanks and these special characters: ' " | are not supported.

DESCRIPTION

Description of the PR4/PR4S connection you are creating. The maximum number of characters is 2048.

STATUS

Enable or disable the client connection. Possible values:

  • Enabled (default value)

  • Disabled

HOST *

Remote host IP Address or hostname.

PORT *

Port to connect to the remote host (1 to 65535).

NODE NAME *

SPAZIO node local name.

QMANAGER NAME

Name of the remote Queue Manager.

USERNAME

Username to be used for the connection. The maximum number of characters is 320.

PASSWORD

User password.

CONNECTION TIMEOUT *

Number of seconds without network activity to wait before closing a session due to inactivity. Default value: 60.

LOCAL QM *

CLIENT KEY LABEL

Key identifier to create the SSL connection

PPS USERNAME

User to enable a secure point to point connection.

LINE TYPE

How many communication channels (i.e. how many sockets) are used in the PR4 session. Values:

  • W1: full-duplex - one bi-directional channel

  • W2: half-duplex - two monodirectional channels

HASH ALGORITHM

Algorithm used by PPS for hashing.

CRYPTO ALGORITHM

Algorithm used by PPS for cryptography.

CONNECT THROUGH DMZ

Enable or disable DMZ proxy. Possible values:

  • Enabled

  • Disabled (default value)

MAX RETRIES

Maximum number of retries. If this field is empty or set to 0, no retries will be executed and the job will be set to Failed if the first attempt is not successful. A high value corresponds to a high number of retrying attempts.

RETRY INTERVAL

This field will appear only if you have set the maximum number of retries to 1 or greater. Time (in seconds) waited before retrying to execute a job. The lower the value, the more frequent the retrying attempts. If this field is empty or set to 0, no retries will be executed and the job will be set to Failed if the first attempt is not successful.

CONFIGURATION TEST

Use this section to test that the Cluster and the STENG are connected correctly. Select a Cluster and a STENG you want to test and click the TEST button. Data One automatically selects a Cluster and a STENG to test the connection. Note that a Cluster will be selected only if it is the only one available. A message with a green check will confirm a successful connection. A message with a red exclamation mark will warn about an unsuccessful connection. The message also details the reason why the connection fails. The connection might not be successful for different reasons, each of them depending on the transport type and the configuration. The first time you try to test the connection, if trusting certificates are missing, an error message detailing the unsuccessful connection will appear. In this case, go to the Setup Untrusted Cache Certificates tab and trust the relevant certificates. Note that trusting certificates in the Untrusted Cache page may not be sufficient to establish a successful connection. Refer to the Untrusted Cache section of this documentation for all the details.

Last updated