Setting up Data Shaper Designer and Processor
The Data Shaper Engine is configured in Data Mover by going to Setup → STENG, Clusters and Servers → Primeur Engine and clicking the NEW SERVER button.
In the Select the protocol of your new server window:
Click Data Shaper Processor at the bottom.
Enter the Server Name and Description for the Data Shaper Processor.
Enter the Port of the Data Shaper Processor.
Click SAVE to confirm.
Repeat the same steps with the Data Shaper Designer at the bottom of the Select the protocol of your new server window.
The Port of the Data Shaper Designer must be 13005.
Once created, the status of the Data Shaper Processor and of the Data Shaper Designer is set to STOP, so you must start it manually.
When done, the Data Shaper Processor and Data Shaper Designer cards will appear in the dedicated PRIMEUR ENGINE tab.
Clicking the Designer card and the Processor card, a panel with further information will appear in the top-right corner.
In this panel, use the pencil icon to edit the server Description and Status and the bin icon to delete the server.
To access the Data Shaper Designer user interface, go to Design → Data Shaper.
Last updated